TYN-I P Controller of Solar Lamps

6. Explanation of output mode: When the LED digital tubes display the reserved number of mode, if demonstrate a discrete number (0-5), then there is pure direct current output. Inductive and condensive load are prohibited.

5. Debug mode: applies to system debugging. It is similar to pure light controlmode, which only disabled 10 minutes delay and retains all the other functions. Load connects when there is light signal and disconnect when not, which is convenient for examining the system establishment

4. General Mode of control: this mode disables light control, time control, output time delay and related functions, reserves all the rest functions. Controller under this mode is used as general controller

3.Mode of Light control+ Time delay: startup process as previous. The load will shut down after work to the reserved time. Time setting table as follows.

2. Mode of The Pure light control: when there is no sunlight, luminous intensity fall to the initiating spot. After the controller confirming signal of startup in 10 minutes delay, the load start to work. When there is sunlight, luminous intensity rise to initiating spot. After the controller confirming the signal of output turnoff in 10 minutes delay, the load stop working.

1. Press down the system establishment button for 5 seconds, after digit LED twinkles, loosen the button, presses once to change the number every time until the number demonstrated on digit LED equals the number of mode chose from table by user. The establishment finishes when digit LED stops twinkling. The number can be observed every time LED lightens up while pressing the button.

4)Instructions for TYN-P controller of solar lamps

4. Please choose multi-strand copper wire with over

rated voltage: 12V or 24V
rated current: 10A
ambient temperature: -20-60
altitude for use: less than 5000 meters