Sell hot runner nozzle @China (Mainland)

For this kind of nozzle,there are 6 small BeCu hot tips at the top ,replaces the normal type that only has one tip,the most important and difficult thing is make it heat up.we tried several times and finally found a avialiable heat tube for it,for this type of nozzle.the plastic melt flows outside of the nozzle and flows along to the outside appearance till the injection points.Thus all the melt will flow deirectly to the injection sprue,which means there is no dead zone during the injection.

contact person:Tina
Skype: anole-01 
Msn: anole-tech-01@hotmail.com  
Mail: service1003@anole-hot-runner.com 
Phone:+8618969601023
           +86057681106952
Fax:+86057684018996
 Welcome to visit our website:
 www.anole--hot-runner.com

Post by Emily Tina    Rubber & Plastics    @2011-12-29 15:46:55