Sell plastic extruding welder @China (Mainland)

Model No: AJ-001

Voltage: 220V

Power Drive Motor 1020 W / Heat Blast 3400 W

Temperature Wind Temperature20—650℃，Heating temperature while plastic extruding is 20—300℃

Warm-up heat blast volume 500L/min

Diameter of Welding Rod φ 3.0mm

Applicable range

Thermal plastic HDPE, PP, PVDF, the PE can show the characteristic best.

It is forbidden to use for the plastic with electric conduction (PE-EL), which can bring electric conduction short circuit of the machine.

This machine is used for the fourth part of the barrel bath and the tube that accords to the standard of the DVS (Germany Welding Association).

It can once weld the welding line with width of more than 10mm and plastic board with thickness below 40mm.

Post by Lena Zhong    Rubber & Plastics    @2012-02-15 15:50:12