Sell led power driver tester with high stability for lab design @China (Mainland)

Introduction:

WT2080 LED Power Driver Test Instrument is the comprehensive test instrument for LED drive power which is according to GB/T 24825-2009 and IEC 62384:2006. It can measure the following parameters: Input Characteristics Test (AC&DC), Output Characteristics Test (AC&DC), Output Start Characteristics Test (DC) and Harmonic Testing. 

Specification:
1. Input Characteristics Test (AC)
    • To measure the input voltage, current, power, power factor, power grid frequency
    • The fundamental frequency scope of the current and voltage: 45Hz~65Hz; Narrowband range: 45Hz~5kHz; Broadband range: 45Hz~1MHz.
    • Voltage range: 3~300 V (CF=1.67); Current range: 5mA ~ 2.7A (CF=3); Power range: 0.015~800 W; Power factor range: 0.000~1.000.

2. Input Characteristics Test (DC)
   • Measuring voltage, current, power.
   • Voltage range: 3~500V; Current range: 5mA~8A; Power range: 0.015~4000W

3. Output Characteristics Test (AC)
   • Measuring lamp voltage, lamp current, lamp power.
   • Lamp voltage range: 3~300V (CF=3); Lamp current range: 5mA~2.7A(CF=3); Lamp power range: 0.015~800W

4. Output Characteristics Test (DC)
   • Measuring output lamp voltage, lamp current, lamp power, ripple wave current.
   • Voltage range: 3~500V; Current range: 5mA~8A; Power range: 0.015~4KW; Ripple wave current range: 5mA~2.5A.

5. Output Start Characteristics Test (DC)
   • Change curve and data of the measuring lamp voltage and lamp current within 0~2 seconds.
   • Lamp voltage range: 3~500V; Lamp current range: 5mA~8A

6. Harmonic Testing
    Total harmonic and the harmonic component of 0~50 times, wave ratio, initial phase angle, peak phase angle, the phase Angle

Post by Raven L    Measurement & Analysis Instruments    @2016-03-07 17:02:47