RPS-L11M Radio Probe System

RPS-L11M radio probe system contains TP200 touch probe, RPDM transceiver, RSI-20M receiver and standard measuring software, applied in lathe probe, multi-tasking machines probe and turning machine probe. The RPDM is a radio frequency probe designed to be turret-mounted for part setting and inspection on turning centres. RPS-L11M radio probe system is for workpiece inspection and job set-up on multi-tasking machines, lathes and turning machines.

RPS-L11M Radio Probe System

RPS-L11M radio probe system contains TP200 touch probe, RPDM transceiver, RSI-20M receiver and standard measuring software, applied in lathe probe, multi-tasking machines probe and turning machine probe. The RPDM is a radio frequency probe designed to be turret-mounted for part setting and inspection on turning centres. RPS-L11M radio probe system is for workpiece inspection and job set-up on multi-tasking machines, lathes and turning machines.

RPS-L11M Radio Probe System

TP200+RPDM：

Measuring direction ±X，±Y，+Z

Arbitrary direction swinging angle X-Y±15°, Z +5 mm

Repeatability （2σ） ≤ 2 μm；

Trigger force in Z direction 600±30（g）

Trigger force in X-Y direction 50-100（g）

Radio signal receiving/sending distance >14m

Model of the standard stylus M4-P50-RB6-S36

Model of the battery 14250，3.6 (V), 2 Pcs

Seal grade IP68

RSI-20M

Radio signal receiving/sending distance >14m

Frequency of the radio signal 2.4-2.483G

Quantity of the radio channel 16

Input voltage 24±10% VDC

Output load current 50mA

Length of the cable 8m

Length of the cable retaining tube 2m

Seal grade IP68

Application of RPS-L11M Radio Probe System

RPS-L11 is for workpiece inspection and job set-up on multi-tasking machines and lathes.

PRS-L11 often used in turning machine to measure workpiece and set datum point.

It provide automated on-machine measurement of component position and alignment. Set up faster, improve quality and reduce scrap.

Technical Characteristics of RPS-L11M Radio Probe System

The stylus connector of TP200 probe is protected by a metal cover and a rubber seal cover;

Switch on/off method of RPD/RPDM radio signal emitter: M code on/off;

Radio code signals are used to transmit information between RPD/RPDM radio signal emitter and the receiver. The time to transmit and to decode a group of signals is less than 1ms;

Globally recognised 2.4 GHz waveband – compliant with radio regulations in all major markets.

The RSI-20 receiver out put trigger、error、probe batteries low and output pulse four kinds of signals. And it's logical state can change normally closed and normally open.

The indicating lights in RSI-20 and RPDM show the working status of the probe system

For more information about touch probe and pioneer machine and tool, please feel free to contact us!