Causes of heat in the pump body

Various problems will be encountered during the use of slurry pumps. Today we are talking about the reasons and solutions for the heating of the slurry pump body.

1. Incorrect selection of the slurry pump results in a mismatch between the pump and the motor, resulting in heat generation. At this time, the motor should be replaced in time to avoid burning out.

2. The theoretical value of the pump shaft power of the slurry pump does not match the actual shaft power, resulting in a small matching motor configuration and overloading of the motor. The reason for the overflow of the water pump at the balance point should be discovered and solved in time.

3. The slurry pump shaft is bent or the two shafts are not concentric. The pump shaft should be checked and replaced or the concentricity of the two shafts should be adjusted.

4. The slurry pump idles for too long, causing the rotor parts and shell to heat up.

5. When assembling the slurry pump, the machining accuracy of the parts of the slurry pump itself does not meet the requirements due to the forced installation and hard insertion method.

If you want to know more about fine sand recycling pumps, please callPansto Pump Industry!

ShijiazhuangPansto Pump Industry is a manufacturer of slurry pumps in Shijiazhuang. It mainly designs, manufactures and sells slurry pumps and accessories. Mainly engaged in mud pumps, submersible pumps, foam pumps, desulfurization pumps and many other series.

Special pump for coal washing Sand and gravel slurry pump High-lift slurry pump Imported slurry pump Heavy-duty slurry pump Horizontal slurry pump Single-shell slurry pump Iron ore tailings pump Tailings slurry pump Slurry circulation pump Lime slurry pump

High pressure slurry pump centrifugal slurry pump