Energy Saving Equipment Lignite briquette machine

Lignite briquette machine

1. Product introduction:

Lignite briquette machine (with adhesive type) mainly has the motor, reducer, mainframe, belt conveyor, the ball slot of the roller set of device, hydraulic system and electric control, etc. Lignite by its own gravity from the feed inlet, into two intermediate pressure and, pressure and uniformly distributed on the surface of the same shape and groove, pressure and constant speed, to rotate in the opposite direction, lignite bite into the groove and forced compression, with pressure and continues to rotate, pressure after lignite material ball in its surface tension and gravity off ball.

2. Use common sense:

1. No matter in what way feeding must be reliable iron removing device, otherwise it may cause pressure and even destroy the whole major accident is arranged in front of the feeding equipment.

2. In order to ensure the normal operation of equipment must be used, can feed the feed material into the mechanical adjusting equipment.

3. Equipment must be related to the equipment before and after the equipment to start and stop the chain.

4. After the normal operation of equipment should regularly check the connection parts are firm.

5. Replacements of bearings, should adjust the bearing radial clearance, the clearance should conform to the standard.

6. Equipment fixed bearing seat and the lubrication point of the sliding bearing seat should be on time to refuel, ensure that the cavity to keep 80% of the grease. Each time the transmission support, should ensure that the pre-press device on the grease from the shaft end of the squeeze out (the purpose is to remove the dust material into the damaged bearing).

7. Hydraulic oil pump, oil filter should be cleaned after a month. Effective working period of 3-6 months after the mail should be cleaned, the replacement of a stand of the winter environment temperature of not less than 5 degrees Celsius.

3. Product configuration:

1. Chinese maximum pressure ball machine manufacturers. And magnesium powder;

2. To provide 520-1200mm roller by a full set of products;

3. Forced pre-press output 11T/cm line pressure;

4. Special bearing steel 6000 hours wear resistant roll surface;

5. Closed gear reducer low noise without leakage;

6. Laboratory of pressure ball to provide incoming material pressure ball test.

Gongyi Fu Yu Machinery Co., Ltd. is specialized in the production of pressure ball machine, welcome to consult the factory, telephone 86-18538292735, http://www.ball-press-machine.com. E-mail:fybriquettemachine@yahoo.com.