QSFP 100G 850nm 100m MPO Transceiver(100g sr4) is a parallel 100Gb/s Quad Small Form-factor Plug-gable (QSFP28) optical module. 100g qsfp28 sr4 provides increased port density and total system cost
savings. The QSFP28 MPO full-duplex optical module offers 4 independent transmit and receive channels, each capable of 25Gb/s operation for an aggregate data rate of 100Gb/s on 100 meters of OM4
muti-mode fiber.
An optical fiber ribbon cable with an MTP/MPO connector can be plugged into the QSFP28 module receptacle. Proper alignment is ensured by the guide pins inside the receptacle. The cable usually
cannot be twisted for proper channel to channel alignment. Electrical connection is achieved through an MSA-compliant 38-pin edge type connector.
The module operates by a single +3.3V power supply. LVCMOS/LVTTL global control signals, such as Module Present, Reset, Interrupt and Low Power Mode, are available with the modules. A 2-wire serial
interface is available to send and receive more complex control signals, and to receive digital diagnostic information. Individual channels can be addressed and unused channels can be shut down for
maximum design flexibility.
QSFP-100G-SR4 product is designed with form factor, optical/electrical connection and digital diagnostic interface according to the QSFP28 Multi-Source Agreement (MSA). 100G sr4 transceiver has
been designed to meet the harshest external operating conditions including temperature, humidity and EMI interference. The module offers very high functionality and feature integration, accessible
via a two-wire serial interface.
Technical Specification Of QSFP 100G 850nm 100m MPO Transceiver
Absolute Maximum Ratings
It has to be noted that the operation in excess of any individual absolute maximum ratings might cause permanent damage to this module.
Parameter Symbol Min Max Units Note
Storage Temperature TS -40 85 ℃
Operating Case Temperature TOP 0 70 ℃
Power Supply Voltage VCC -0.5 3.6 V
Damage Threshold, each Lane THd 3.4 dBm
Recommended Operating Conditions and Power Supply Requirements
Parameter Symbol Min Typical Max Units Note
Operating Case Temperature TOP 0 70 degC
Power Supply Voltage VCC 3.135 3.3 3.465 V
Data Rate, each Lane 25.78125 Gb/s
Control Input Voltage High 2 Vcc V
Control Input Voltage Low 0 0.8 V
Pre-FEC Bit Error Ratio 5x10-5
Post-FEC Bit Error Ratio 1x10-12 1
Link Distance (OM3 MMF) D1 70 m 2
Link Distance (OM4 MMF) D2 100 m 2
As an optical transceiver factory, we can offer sorts of related products for sale, if you have needs, please contact us.
